1. The hardened gear reducer must be installed on a rigid, flat base. The paint and grease on the mounting surface must be cleaned before installation.
2. The minimum performance level of the connecting bolt is 8.8.
3. The coaxiality error between the axis of the input and output shafts and the working machine and the motor shaft line shall not exceed the allowable value of the coupling; if the belt drive input power is used, the tension of the belt shall comply with the regulations to avoid Causes additional radial forces.
4. Couplings, pinions, etc. are not allowed to be fitted to the end of the shaft by means of a hammer.
This installation method is also applicable to gear reducers.
This article is from: http://
Touchless Thermometer,Infrared Forehead Thermometer,Contactless Thermometer,Digital Forehead Thermometer
Chengdu Augus Science Technology Co., Ltd. , https://www.vluckyaugus.com