1. Use: One-component silicone glass glue can be used immediately, it can be easily shot from the plastic bottle with a glue gun, and the surface can be trimmed with a spatula or wood chips.
2. Sticking time: The curing process of silicone adhesive is developed from the surface inward. The drying time and curing time of different properties of silica gel are different. Therefore, if the surface is to be repaired, it must be done before the glass glue is dry. (Acid glue, neutral transparent glue should generally be within 5-10 minutes, neutral variegated glue should generally be within 30 minutes). If you use color separation paper to cover a certain place, after applying the glue, be sure to remove it before the skin is formed.
3. Curing time: The curing time of the glass glue increases with the increase of the bonding thickness. For example, the acid glass glue of 12mm thickness may take 3-4 days to solidify, but within about 24 hours, there is a 3mm outer layer. Cured. When bonding glass, metal or most wood, it has a peel strength of 20 lbs/in after 72 hours at room temperature. If the glass glue is partially or completely closed, the curing time is determined by the tightness of the seal. In an absolutely closed place, it is possible to remain uncured forever. If the temperature is raised, the glass glue will be softened. The gap between the metal and metal bonding surfaces should not exceed 25 mm. In all kinds of bonding occasions, including sealing, the bonding effect should be thoroughly checked before using the bonded equipment. During the curing process, the acid glass glue will produce a smell due to the volatilization of acetic acid. This taste will disappear during the curing process and will have no odor after curing.
4. Bonding: A. Thoroughly clean the surface of the metal and plastic, remove the oil, and then rinse the entire surface with acetone except the plastic. The surface of the rubber is sanded with a sandpaper and then rubbed with acetone. Observe the precautions when using this solvent when using acetone. B. Apply the glass glue evenly on the surface of the prepared object. If the two surfaces are bonded together, place one side first and then squeeze the other side to squeeze out the air with sufficient force, but pay attention to it. Do not squeeze out the glass glue. C. Place the bonded device at room temperature until the glass glue is cured.
5. Sealing: When silicone glass glue is used for sealing, it is also carried out according to the above several steps, and the glass glue is forced into the joint surface or the gap to make the glass glue fully contact with the surface.
6. Cleaning: Before the glass glue is uncured, it can be wiped off with a cloth strip or paper towel. After curing, it must be scraped off with a scraper or solvent such as xylene or acetone.
Main functions:
Rear wash, feminine wash, massage wash, kid wash, Seat heating, warm air drying, Soft close, seat sensor, night light, Water temp adjust, air temp adjust, seat temp adjust, nozzle adjust, Instant water heating, IPX4 water proof, Side control panel, remote control, Energy saving mode
Extra functions:
automatic open/ close, automatic flushing, with Super flushing system by own research and development
Direct factory with professional R&D department, product range covers Smart Toilet, Bidet cover, toilet seat, tank fittings, flush tank, flush valves, and intelligent toilet.Intelligent Toilet,Smart Toilet,Electric Toilet,Innate Intelligent Toilet
XIAMEN JIEENTE IMPORT AND EXPORT CO.,LTD , https://www.jieentexm.com