The hanging door is a kind of door that supports the sliding with a hanging wheel. When the door is opened, it has no noise, no threshold, beautiful and generous. The profiles of hanging doors on the market are divided into titanium magnesium aluminum and recycled aluminum. Then, the following Xiao Bian will introduce you to the installation steps of the hanging door. Hope to help you!
1. If the package is opened between the door frame and the wall, check carefully whether the products and parts are intact.
2. Take out the door frame and put the front of the material up as far as possible to avoid scratches. The floor is best to be covered with cardboard or carpet.3 , the upper slide hanging wheel in the correct order into the upper chute, the frame and the crossbar frame correctly assembled and half-section self-tapping screws ( joint must be flat ) . Special note: The upper hanging wheel must pay attention to its arrangement, so as to avoid rework.
4. Put the assembled door frame into the door hole, first horizontally and vertically seal the left and right door frame, position the hole, and fix it with the expansion screw, (the screw should not be fixed too tightly, so that the clearance when the door leaf is installed ) is too large, Use a thin plate or other object to stuff it inside.
5 , with louvers, should be guaranteed horizontal and vertical, square above the guide rail above, and punching with expansion screws ( if the wall gap is too large, then use a thin piece of wood after the plug is fixed ) After installing the louver, the door chute The lower frame of the louver is screwed and fixed with a screw. The louver without the louver is directly drilled in the appropriate position of the upper chute with the drill tip and fastened with the top wire ( do not overtighten the top screw so that the entire next step can be fine-tuned ) .
6. Once again, adjust the overall door frame to the same plane and keep it vertical. Then, tighten all the screws.
7. Whether the pulley is at the same height and is in line with the height of the site. If they are equal, the door can be hung. If it does not match, adjust to a suitable position and then hang the door ( note: the correct direction of the front and back of the door ) .
8. After the door leaf is hung up, debug the horizontal condition of the upper pulley again. After the tamper effect and the lock are correct, prepare the positioning wheel.
9. In the natural vertical state of the door, determine the installation position of the door fan positioning wheel, draw a good line, remove the door leaf, and fix the positioning wheel with the correct screw of the positioning wheel.
10. Hang the door and check whether the gaps between the two doors are uniform from top to bottom. If the unevenness is fine-tuned to the proper position and test the level of the door sash, the slamming effect and the safe and secure opening of the lock, etc., until everything has achieved the best effect, Remove the door leaf, tighten the positioning wheel screw, hang the door leaf again, and tighten the upper slide wheel alignment adjustment screw.
Xiao Bian summary: The above steps on the installation of hanging doors Xiaobian to roughly introduce here. For more information on home improvement knowledge, please continue to pay attention to information on this site!
Door and window installation
Tile Insert Floor Drain,Tile Insert Floor Drain Cover,Tile Insert Stainless Steel Floor Drain,Black Linear Tile Insert Floor Drain
Kaiping City Jinqiang Hardware Products Co.,Ltd , https://www.jmpowerdrain.com